Heat Tool
$35.00
Use the Resin Craft by Me™ heat tool to quickly remove bubbles from resin. The heat tool is also helpful for moving uncured resin around in projects.
Directions:
1. Plug in the heat tool and turn on. Allow to warm up for approximately 10 seconds.
2. To pop bubbles, wave the heat gun approximately 2 inches from the surface of the resin until the heat forces the bubbles to pop.
Caution: Do not use near water.
Dry location only.
The heating temperature of this heat gun can reach up to 392°F (200°C).
WARNING: Not intended for children age 12 and under.
The maximum time of single use should not exceed 3 minutes.
Specifications:
Temperature 392°F (200°C)
Watts 300, Amps 2.5, Volts 120V